All posts on May, 2008

MIDIATOR

MIDIATOR
This converts a PS2 controller into a MIDI controller. The current firmware supports remapping of the buttons to different notes or controllers. It’s based on a PIC microchip–full, explained source code and instructions for making modifications are supplied. [more]

Posted in : PIC projects

T-Clock

T-Clock
Demo-application for Philips LPC2000 ARM7TDMI controller with a KS0108/KS0107-based graphics-LCD (128*64 pixels), DCF77 time-receiver and Onewire-Bus (for DS18×20-Temp.-Sensor).The time and date are received with a DCF77-receiver-module .The DCF77-signal is transmitted from a station near Frankfurt/Main, Germany and can be received all over Europe, North Africa and the Middle-East. [more]

Posted in : Clock projects | Sensor projects

3-digit frequency meter for SwissFlow flowsensor

3-digit frequencymeter for SwissFlow flowsensor
This schematic is ment to digitally display the output of my electronic Swissflow SF800 flow sensor. This sensor puts out an open collector square wave signal (like a fan RPM monitoring signal) between 50Hz and 2000Hz . By dividing the measured frequency by 10 and putting the decimal point at the right place you get directly a display in liter/minute.[more]

Posted in : Display projects | Measurement projects | Sensor projects

Digital Oscilloscope

Digital Oscilloscope
his is a student project from Cornell University.It designed by Reid Gurnee.He writes:
My senior project is to design and build a digital oscilloscope for Professor Land. This project involves a number of design challenges. On the analog side, I need a fast, low noise A/D converter. In addition, the circuit requires a -20V bias from a 5V supply. In the realm of digital, it involves interfacing two micro-controllers with each other, an LCD display, and an analog to digital converter. With such a broad range of challenges, I searched for help from my professors and contacts I made on the web. I was successful in getting help on floating point arithmetic for an 8 bit micro-controller and LCD interfacing.

Posted in : AVR projects | Measurement projects | Oscilloscope projects

HERO Robot Remote Control

HERO Robot Remote Control
HERO Robot Remote Control interface using the BASIC STAMP II.This interface uses a Basic Stamp II controller which is wired to the Teaching Pendant Connector (molex style). It is used to simulate most of the functions on the Teaching Pendant Controller. [more]

Posted in : Remote control projects | robot projects

« Previous PageNext Page »