All posts on June, 2008

Four Channel DRO

Four Channel DRO
Each encoder channel has a dedicated microcontroller, this feature gives it a high speed encoder tracking ability.It will track at up to 30 KHz ! All four channels are controlled by a main chip. The main chip takes care of calculating values for the LCD display.The main controller uses 32 bit counters so there are no practical limits for it’s use.[more]

Posted in : Display projects | General electronic projects

24 bit Delta Sigma ADC with USB Interface

24 bit Delta Sigma ADC with USB Interface
This unit uses the LTC2400 Delta Sigma 24bit ADC chip connected to a Cypress Semiconductor CY7C6300 which is a low speed USB device.[more]

Posted in : USB projects

Two channel serial thermometer

Two channel serial thermometer
The circuit uses a constant current drive and a four wire connection to the probes. This allows almost any length of probe connecting cable without re-calibration.The current is set to 1.000mA. The circuit use MAXIM MAX4194 series of precision differential amplifiers. [more]

Posted in : Measurement projects | Sensor projects

Portable Universal Radiation Spectrum Analyzer

Portable Universal Radiation Spectrum Analyzer
This Portable Universal Radiation Spectrum Analyzer has many advanced features based upon the experience gained from the original design by Wedemeyer. The signal to noise ratio is significantly higher and therefore reduces count time as well as allowing a better low end range, high end range is of course as good as ever.[more]

Posted in : Measurement projects

DC motor speed control using PWM

DC motor speed control using PWM
This is DC motor speed control based on PIC16F867.The circuits use frequency PWM about 10KHz which does not make a noise in the motor.This project can drive 1 Amp motor current without heat.The motor speed controled by potentiometer which is connected to ADC input.[more]

Posted in : PIC projects | motor controller

« Previous PageNext Page »