All posts on September, 2010
This project for testing CCPM servo setup. This device allows you to connect 1-3 servos simultaneously. It can be used as a servo signal generator for testing electronic speed controller (ESC) without using a transmitter and receiver. Also, this device can be used to check other RC devices.[more]
The Sabertooth 2X5 R/C will be used to interpret signals from a radio control system, and vary the motor speed so you can drive the robot around. The project requires basic knowledge of electronics (Volts, amps, battery polarity and wiring) and intermediate soldering skills. The project can be completed in a day, with most of the time spent waiting for glue to dry. [more]
