All posts in the 'Battery Charger' Category



Battery Discharge Analyzer

 

Battery Discharge Analyzer
This project builds a simple automatic battery discharge analyzer. It can be used to measure the discharge characteristics of the batteries. The output data can be expressed into a graph with a spreadsheet by sending data to PC via RS232.[more]

Posted in : AVR projects | Battery Charger

Artificial Plate Battery

 

Artificial Plate Battery
Plate batteries for old tube radios are today only available with difficulty. However, step-up controllers for low DC voltages are everywhere. The circuits of these IC’s are, however, affected by disadvantages and complex wound inductances are needed. A further disadvantage of this solution is the transducer frequency; poor placing can cause audible interference.[more]

Posted in : Battery Charger | Power supply

Advanced USB Device Charger

 

Advanced USB Device Charger
This is a tiny USB battery charger.With this tiny thing you can charge almost all devices that are charged via USB, like iPods or mobile phones, with only two AA-Cells.most important compenent of the cicuit presented in the next steps is the “LT1301″. This is a small step up converter for to build switching mode power supplys with only a few external components.[more]

Posted in : Battery Charger | Power supply

Battery Charger for Hand Held Radio Battery Packs

 

Battery Charger for Hand Held Radio Battery Packs
This is a handy little charger that can provide a charging current of up to 120 mA continuously for batteries in the range up to 12 volts.The supply is housed in a small plastic enclosure 90 x 55 x 32 mm.[more]

Posted in : Battery Charger

LiPo element calibrator

 

LiPo element calibrator
The LiPo calibrator built is a very simple circuit based on the LM317, one resistor and one trimmer that can give a voltage from 4 to 4.5V. The trimmering range (around the point of start) should be minimezed in order to have a very good and easy adjustement with a standard multiturn trimmer. If the user has a very precise and stable power supply or another adjustable power supply (capable to be trimmered at 4.200V) it can be used to calibrate the LiPo balancer element.[more]


Posted in : Battery Charger

Next Page »